Sparky Channel

0:12:56

EMT Conduit Bending: Four Point Saddle Bend with Multipliers, Shrink + No Charts or Apps

0:08:30

EMT Bending: How To Make a 3 Point Saddle Bend Without Charts or Apps

0:05:51

How To Make 30° Offset Bends Using Multipliers and Shrink

0:05:47

How to Make a 90° Stub on the Star, and Make it Fast!

0:07:10

How to Make Back to Back 90° EMT Bends

0:09:00

How To Make EMT Box Offset Bends

0:18:40

How To Make Parallel EMT Bends with 4 Point Saddle Bends and 90° Stubs

0:05:47

Will a Metal Box Alone Provide a Ground for Electrical Wiring?

0:04:12

Storytelling by an Electrician

0:15:37

Box Offsets, 3 Point Saddle Bend, Parallel EMT Bends and Concentric 90° Stubs all in One Conduit

0:10:23

Push-Through 3 Point Saddle Bend: Easy, Fast and Good for Tight Spaces

0:08:38

How To Make a 4 Point Saddle Bend with an Angle Setter Conduit Bender

1:07:47

IDEAL National Championship 2019 Pro Finals: Service Entrance Cable, Torque, Panels and Breakers

0:20:58

How to Wire a 4-Way Switch System

0:16:28

How To Wire a 3-Way Switch System

0:06:05

How to Make Accurate 90° EMT Stubs with 1/2', 3/4' and 1' EMT Conduit

0:09:54

How to EMT Bending: Box Offsets, 3 Point Saddle Bend and Back-to-Back 90's All in the Same Run!

0:09:24

Watch a Pro Wire a 20A GFCI and 20A Receptacle, Any Code Violations?

0:07:58

EMT Bending 'Kick': By Eye and Measured

0:21:01

2 Prong Receptacle Circuit Replaced by GFCI and Grounded Receptacles per 2020 NEC

0:16:44

Box Offsets, 4 Pt. Saddle Bends, 90° Stubs and Adding to Parallel Bends

0:04:42

Feed-Through Conductors 2023 NEC 312.8 (A) and (B)

0:14:10

Half Hot Receptacle with Power to Switch Installation

0:10:05

How to Install a Combination Switch and Receptacle